Insulated large female spade connector for 9.5mm male terminals

Crimp type

 More than 5 in stock

Insulated medium female spade connector for 6.3mm male terminals

Crimp type

 More than 5 in stock

Belt for Bosch generator

 This part is due back in stock soon, call 01484 841395 to reserve yours

12702505-z 12702505 GU12702505 12 70 25 05
 1270 2505 1270.2505 12.70.25.05

Belt for Marelli generator

 This part is due back in stock soon, call 01484 841395 to reserve yours

12702500-z 12702500 GU12702500 12 70 25 00
 1270 2500 1270.2500 12.70.25.00

Crimp on HT lead connector, also used on loop frame distributors

We recommend checking your bike uses this type of connector before purchasing

 More than 5 in stock

One metre of copper core HT lead, this is superior to the more commonly available carbon core lead

Sold by the metre, one metre is enough for two leads on most models with coils under the fuel tank. For models with coils under the side panel you will need two metres. See ELA14715 and ELA14714 for plug caps and ELA20001 for coil screw cap. See ELA00001 for crimp on HT lead connector

 More than 5 in stock

Kit containing two replacement 60cm silicon HT leads, lead ends and 90° plug caps. The leads are suppied as a single double length lead so you can cut it into two leads of the exact required length. Includes crimp on lead ends for standard big twin 12v round coils

Suitable for most models with coils under the tank where the HT lead is not moulded into the ignition coil. We recommend checking what type of plug cap you have and measuring your existing cable run to check this part will fit

 This part is due back in stock soon, call 01484 841395 to reserve yours

12 volt single output 3 Ohm ignition coil (lead to distributor)

Push fit HT lead, see ELA00001 for crimp on HT lead connector. Supplied without coil clamp

 This part is due back in stock soon, call 01484 841395 to reserve yours

 26716504 GU26716504 26 71 65 04
 2671 6504 2671.6504 26.71.65.04

Silca key blank for Zadi ignition keys - match profile to your existing key

 3 in stock

ZD9

Silca key blank for ignition key, match profile to your existing key

 This part is due back in stock soon, call 01484 841395 to reserve yours

NE5